Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanx for replay,
I wanted to know more about transition violation. is we have to give preference to transition violation over setup and hold violation? OR hold vioation has to give more priority for fixing as it is independant of frequency?
Hello all,
Metal filling is done after the design is complete to keep an uniform metal density to avoid dishing and erosion effect during chemical mechanical polishing.
But Metal fills, we used are floating or connected to power lines? which is types of metal fills normally used?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
