Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all
when i try to generate the pcb netlist in DxDesigner it gives following Error
Error 6000: Couldn't open file...i checked Error on Help in that mentioned couse for error is " The indicated file is not readable or writeable"
but my file is readable or writeable . guys if know the solution...
:roll:hi friends i want to simulate high speed differential nets those are connected from Q-seven module to displayconnetor.so simulating these nets i need IBIS module of connector required but i dontknow how create connector module in hyperlinx..if you know please help me ....
thanks in advance
Actually i am placed common mode chock for lvds and HDMI nets those nets connected between qseven module and displayport and those nets are high speed differential nets.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
