Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello uakashamustafsa,
post the exact error what you are getting .I would suggest you to post the screen shot of error.
What u did is wrong,and not followed the suggestion from atripathi.
open a new schematic--> delete everything from the library.
open this path...
Thanks for your valuable inputs.
But it is my mistake I did nt give the complete details.
actually It is a very big project,all the ADCs in the uC were used .now no ADC left for the present requirement.Now I have left only choice to use digital ports in uC.It is not possible to change the uC...
Hello,
In my microcontroller ,there is no ADC available.i have digital ports.I want to use the digital ports for replacing ADC.
Is it possible?
Regards
Ravi
Hello ,
A component was with Pb in first generation.In second generation now the component is pb free.
What are the Tests(performance and validation......) needed to determine the performance of Asic?
how the circuit will be effected?
As far as i know there is no change in performance of Asic.
Hi goldsmith,
My inverter output power rating is 300W,120 Vpk,5 Apk,30Hz pure sine wave.
presently our load is 10 ohm,8mH,which is variable.
Presently we dont have feedback,it includes in future planning.
I heard closed loop of inverter is somehow difficult ,please provide the good stuff for...
I want to sense the inrush current and as well as over current ,i want to protect my circuit from more than rated current.if i use a current sensor and protect my circuit,circuit will be tripped during inrush also,which is not my requirement.I should not use NTC also because i want to moniter...
The voltage across the r39, r40 should be 0 to 28v pulse with 2usec pulse width,but is 28v to 28.4v pulse with 2usec pulse.if we think when the switches are off the total voltage will be present across those resistors,but it is not showing in simulation.if we start the pulses then only i am...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
