Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all
can anyone provide me FFT code in AHDL or VHDL as an example, bcz in @ltera website they just displayed a diagram nothing else.
for N=32 and data rate is 128 Ksbs.
I shall be very thankful to you.
01 Dec 2006 7:53 FFT in AHDL
--------------------------------------------------------------------------------
Hi all
can anyone provide me FFT code in AHDL as an example, bcz in @ltera website they just displayed a diagram nothinelse.
Actually i have to write a code for 64...
Plz help me to write a code for FFT in AHDL.
Can anyone provide me any example of FFT in AHDL.
I also could't find in Altera website as well.
I shall be very thankful.
Hi all
can anyone provide me FFT code in AHDL as an example, bcz in altera website they just displayed a diagram nothinelse.
Actually i have to write a code for 64 transform length and 8bit data.
I shall be very thankful to you.
Thanks.
can anyone give me the filter example in AHDL.
I shall be very thankful to you. I went to altera website but they just display the block diagram. nothingelse.
Thanks.
Hello everyone
i want to design FIR filter in AHDL with 8 bit data width and 20 Taps.
I am new in this language and unable to do this. so plz anyone can help me regarding this design.
I shall be very thankful.
Hi guys
i am looking for the basics of AHDL programming structure book. I am new to use this language.
so i want such a book or online material which could provide me some examples in AHDL and its programe structure.
Thanks
virtex-ii pro xc2vp30
HI
Is there anyone who has used this board link is as follow
http://www.digilentinc.com/Products/Detail.cfm?Prod=XUPV2P&Nav1=Products&Nav2=Programmable
FPGA IC: XC2VP30
Actually i want to know about its one of features which they have written as follow
" High and Low...
Hi
i make my statement more clear.
for downcoverter
i want output 2 MHz from the A/D converter .
While using the s band or 800 MHz input in converter. So tell me what IF should i used to get 2 MHz from A/D converter.
And also advise me about the sampling technique as well in the A/D converter...
rf uav
Hello to All
Currently i am working on small UAV communications. I need up and down converter to work with ISM Band (say 430,800 or 960 MHz) with up to few MHz bandwidth.
Plz, anyone can tell me from where i can get preassembled this circuit with cheap rate.
Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.