Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have transmitted the temperature value through UART using XBee S1. Now I want to transmit the Wind speed through UART. Can I transmit wind speed and temperature at the same time from the same microcontroller which is pic16F877A because transmitter pin is only one which is pin 25.how to...
I am using CCP module of pic 16f877A. measuring frequency then converting it to angular speed.I am using TMR1 module of pic16f877A and mikroC for coding.
Hi,
I want to measure wind speed using a simple fan and IR sensor.The output of IR sensor is 0 and 5V.I used a slit having 20 wholes in it.I have programmed in mikroC. When I rotate the fan with hand sped changes but at rest speed is constant which is 53 m/s. I thing there is some thing...
Hi,
Thanks to all of u for helping me a lot.
I have read the value from Lm35 Temperature sensor and displayed on lcd. now I want to to transmit this value to other microcontroller through XBee s1. I have bought two Xbee s1. I have checked these individually with Hyperterminal and X-CTU...
PIC16f877A UART with XBee pro s1
Hi,
I want to interface XBee pro s1 with PIC16f877A.I want to transmit temperature Value through XBee pro s1 to other XBee .I used Lm35 temperature sensor and PIC16f877A. How to configure UART.please help me to solve this issue.
Re: Showing temperature on Lcd using ADC of Pic 16f877A
I have connected 4.7k resistors with four pins of ucontroller which are connected to LCD but output does not shows.
Re: Showing temperature on Lcd using ADC of Pic 16f877A
I have changed the biasing of contrast adjust pin of Lcd but output does not shows. please tell me that is there any error in configuration of ADC module?
Showing temperature on Lcd using ADC of Pic 16f877A
hi,
I Want to measure temperature value from LM35 temperature sensor by using ADC of PIC16f877A. I made circuit in Proteus. I used this code. It is working in Proteus but on breadboard only Lcd back light on and black squares appear but...
I used Pic16f877A ucontroller and lm35 (temperature sensor). and take temperature value in proteus but on breadbord only switch on the Lcd and black square appears but output does not shoes. I used mikroC Pro for programming.
code is given below.
// Lcd pinout settings...
Hi,
I want to get value of Temperature from temperature sensor and by using ADC of Pic I want to send it to other Pic U controller using XBee module.please tell me how to interface pic with Xbee.I need your help.
my circuit for temperature sensor is this.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
