Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello All,
I need to connect an 8 bit SRAM (for instance, this: https://www.issi.com/WW/pdf/61LV5128AL.pdf ) to my Zedboard. I think I can make a PCB, solder the SRAM onto it and use the FMC connector in order to connect it to the Zedboard. However, I would like to seek for some cheaper and...
Hello Dear All,
I have a unipolar 5V stepper motor and I want to drive it with a 16f877a.
I have connected 2 pieces of tc4427 mosfet drivers and 4 pieces of IRF2807 to the pic and, as I see they are working properly.
I supply 50V to the motor and I am trying to use microstepping techniques...
Hello Dear All,
I want to turn on and off a 40W, 220V AC Motor with logic signals(from pic). Please do not offer using a relay because this process will be done with short time periods(ie. 2 seconds) and the system will work for very long times.
Briefly, I need a circuit that switchs AC...
Hello Dear All,
I have a 220V to 50V transformer. I wanted to build a AC rectifier for it to get 50V DC. Then, I have connected a full wave bridge diode and two pieces of parallel 100V, 1000uF electrolytic capacitors together.
My problem is that; when I measure voltage of the transformer, it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.