Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you are novice in micros, you can download and try Bascom-AVR (demo version - more than enough for beginning) from https://www.mcselec.com .
It comes with a lots of examples in Samples folder.
There are application notes about bascom programming on www.mcselec.com
24 to 12 regulators
don't sure about amps and volts, but maybe this will be useful The 2-transistor Black regulator
https://www.romanblack.com/smps/smps.htm
benq m23 gsm module manual
Hi!
Look at
**broken link removed**
in the downloads section (page in russian, 4 pdfs - english)
BenQ M23 Cellular Engine Module Description ,
BenQ M23 AT Commands ,
RTC Backup Battery Circuit for M23 ,
M23_M23G Designguide Rev_01
Most valuable for me was AT...
Re: AVR c sample codes
Hi!
I think you can download demo versions of codevisionAVR (www.hpinfotech.ro), ImageCraft ICCAVR (www.imagecraft.com) etc (try google), which all have huge amount of samples. And I forget mention free WinAVR C compiler, www.avrfreaks.net has much projects.
Regards
Hi!
You can do search on edaboard ebooks about 8051 uCs and embedded C.
Simple LPT port programmer for SiLabs devices https://www.dilogic.hr/downloads.html
Re: Linear motor
Hi!
You can find a lot of info in patents. (I did)
Look at www.freepatentsonline.com for american and some european pats (text form or pdf) or ep.espacenet.com for worldwide pats (no text, pdf only) or www.uspto.gov/patft/index.html - US PTO (text, tiff's, full text search)...
I dont know is spartan 3e starter kit the best board but I purchased it recently (~ usd200 with delivering (Russia)).
Spartan-3E Starter Kit Board Design Examples
www.xilinx.com/products/boards/s3estarter/reference_designs.htm
Good luck!
Re: A PCB question
2 arschleben
Hi!
I print normal if I want through holes pcb and print mirrored if I need surfacemounting. (In case of one sided pcb).
Regards![/b]
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
