Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all,
I am solving a complex geometry problem. I am getting below error when i run. Please help me..
Surface of all triangles in m*m: 133856.062
Length of the segments in m: 1.
Minimum edge length of triangles in m: 1.15143165E-006 (edge 2581)
Maximum...
Hi
I have come doubt in the code given in the book"antenna and EM modeling with matlab" by sergey N.Makarov. Why they have introduce offset while plotting the radiation pattern. Please do reply
Thankyou
hi
i totally have zero knowledge on numerical techniques. i want to use ptd (not using commercial available software) to analyse antenna radiation pattern when attached on complex body. i want to read abt basic formulation in ptd. please suggest some book r materials.
thankyou.
Hi
I have ' n ' number of antennas of same and different frequencies placed on a platform. when all antennas are excited how to see the individual antenna farfield pattern in feko. The farfield pattern of 1 antenna due to the effect of other antennas in feko. Plz help me..
Thankyou
Hi
my antenna beamwith is 70degree. I simulated by placing 3 of my antenna at 10lambda seperation between them in free space. I could see more ripple in my far field pattern. Why more ripple? can any one explain?
Thanks
Hi
I want to design a mixer using BJT in ADS. I referred many materials but dont no how they have biased bjt. In ADS cookbook mixer design example is available but no complete explanation to choose bjt DC operating point.
please help me to find out VCE, Ic, Ib,VBE of a bjt.
iv curve BJT
Hi
i want to design mixer using BJT. Like active region of IV curve is used for amplifier design. Which part of IV curve is used for mixer design?? Why?? . Help me.
absorber design in feko
Hi
any one tried to simulate EMC absorbers in feko?? i need to do it.i didnt get proper idea abt absorber material ?? plz give some suport.. any good links r paper??
thankyou
Hi enrico
My coil is 10cm dia with 16 turns excited with 30mA current.now i need to analyse in 10KHz range.. in this case what can be my mesh size?? any futher help u can provide??? one more thing can we use CST Microwave studio in Hertz range?? will it work in lower freq range?? what is the...
Hi
I have placed a dieletric cuboid and polygonal plate back to back with 0.1m spacing and excited with a isotropic source. when i use MLFMM i m getting " Error 32536 : Losses are too large when using dielctric bodies with FMM". How to solve this??? Can anyone help me????
Thankyou
help needed in CST
Hi
I am new to cst software. I m trying to make a coil excited with current source. I got this error(" Mesh representation of discrete port1 is a single point"). Then i increased the mesh n simulation ran but didnt reach the steady state condition..What i need to do to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
