Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can anyone convert this Pic 16F84 asm code and put it into C language.
; Generated by WinPicProg 1.91, (c) Nigel Goodwin 2002.
LIST P=16F84, F=INHX8M
include "P16F84.inc"
__CONFIG 0x3FFF
ORG 0x0000
MOVLW 0xFA...
Re: PCB design for VHF
You must use double sided board, The part that the components will be showing is the full copper side so do not etch away this side. it acts as a ground plane.
Use a over size drill bit to open around the holes the components are passing through, so the legs will not...
Re: Creating a PCB
Take Mbyka link it is the best way to start. In a couple of days you will be making simple PCB under 1 hour. That is how I started.
Reqiured Checklist:
Gloves & Goggles
Photo resist board
Small Jig saw, fine blades.
PCB program
Injet printer
Injet transparent Flim
UV Light...
Re: avr programmer.
amr_electron
I use ICProg Version 1.05D
My settings:
Setting>>hardware: Direct I/O has a check, LPT1; Fun Programmer.
Setting>>Options>>Misc: Enable NT/2000/Xp driver is checked.
Scroll down to the orange part of the link and it will help you configure the driver...
Re: avr programmer.
Seadolphine 2000;
I built the simple programmer by amr_electronut above but cannot get PonyProg to
program the AVR2313
Added after 1 hours 12 minutes:
I was able to get ICProg to work using the Fun Programmer settings
Node
74hc959
I too will like help with this IC. I am a Bascom AVR user; I will like to know how to go about making a data table using Bascom AVR, to make my 7 segment Led light.
I have two seperate Led connected to the shift regiter connected to a AT90S2313, using a 10Mhz crystal.
This is how it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
