Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I connect the transistors bulk to a resistor and than to the ground in order to transfer more power to the load, less power goes to the ground. So, how should i simulate the RF_PAD?
The transistor and the PAD have the same SUB, and the PAD has a pin to the SUB.If i connect the bulk to a...
Hi im new in layout design ,i have a few questions:
1.if i have a transistor which his bulk is connected to a resistor and than to the ground, is that mean that if i have an RF_PAD with a connection to SUB i
need to connect it also through the resistor?
2. i have an RF_PAD with 2 input...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.