Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
The defined of lumped port is easily to me.
But I don't understand your question, maybe you can take a picture about feeding point, that's availed us.
Best regard
Hi all!
I'm want to ask a question about band-reject design?
If i used a slit to generate a band-reject characteristic on antenna design, why is the length of slit usually design at quarter-wavelength of rejection frequency?
What's the phenomenon means?
hi llololl!!
The uwb application spetrum is from 3.1 to 10.6GHz. At your simulated results of antenna gains, I could assumed in the higher band(7-10.6GHz) has no resonate mode exist. You can adds a short current path to generate a mode. Therefore, a wideband operating can be obtained.
cPoL&XPoL?
Hi vaakaa,
There is the radiation patterns steps in HFSS...
1. insert far field setup > Infinite sphere.. and set phi and theta.
2. results > report type : far field, display type : radiation patterns
3. in sweep part: select "sweep design and project variale values, Description of...
hfss monopole antenna edaboard cpw
hi kwokhinglai!!
The design of the file "LumpPort for CPW.rar" has a badly mistake, that is the "air objects" is no boundary exist. You have to set the air becoming assign boundary > Raidation. And, run it. That will be ok.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.