Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this is my project print preview
- - - Updated - - -
i have problem with pcb print.
i work on project suddenly my lap top turn off (its battery is finished). after i turn on laptop and go to altium i see that my project is disturb.
but i open it from history that work on it. but when i want to...
i can't understand what you say. i have datasheet of sensor but i can't drive this sensore i attach the data sheet and the brochure for calibration this sensor:
i can't find figs1 and 2 that is Mentioned in page 2 of brochure:bang:
HI
I want to connect it to PC . i use MAX232. but i can't see any text in Hyperterminal screen. i thinck my module is'n turn on because when i call to it oprator say "your set is turn off"
when i turn module my sim VDD voltage is 1.83v
i can connect module to pc but can not send sms. i rescive...
hi i use sim900 module. u can see it's Schematic in this:
https://www.open-electronics.org/small-breakout-for-sim900-gsm-module/
but wen i turn on this module it's NETLIGHT be turn and blink but when i call it say " the cell phone is turn off" i want use only sms
can any one help me?:sad:
hi
I turn on my module with sim300cz-hd-v1.01 . I think my module has same pinout. when I push the PWRKEY and connect to GND my NETLIGHT led turn on and start to Blink. but I don't receive any data in HyperTerminal. I check pin voltage, voltage of SIM VDD is 0.what you think? what's the...
hi
tanks for attention. I check that document but it isn't useful for me . I want sim300cz-v3.04 datasheet .it is important to Note to this Phrase "cz-v3.04".
hi
I want to send message with PC . I buy sim300cz-v3.04 module to send and receive sms from PC. I can find the Schematic for it. and find datasheet of SIM300CZ_HD_V1.01 datasheet. I connect it pin According to this datasheet . but I can't use it , it has not any out put. I check voltage of pin...
hi
tanks for assistance i can see the reasonable output. but i my module can not detect my Latitude and Longitude. it shown the true time but can not detect true Latitude and Longitude
i check baud rate in the module datasheet write " it's baud rate is 9600 " and i select 9600 baud rate for hyper terminal. but i see the Unclear shape like Delta shape
hi
i have gps module (GMS6-cr6). i conecte its vdd ang ground wire. and then i conect it's RS232 port to PC. and run Hyper terminal program but i cant see true data .i see the below image. can you help me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.