Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by naseer_39

  1. naseer_39

    [SOLVED] diff between overlapping and non overlapping in fsm

    Check this link for understanding the difference between them. **broken link removed**
  2. naseer_39

    Verilog Error!!

    Hi, Remove semicolon after always block sensitivity list and add begin and end. Naseer
  3. naseer_39

    QDR II SRAM MIG IP Core with Virtex 7 FPGA

    Hi all, Our requirement is we need to support two 32 MB QDR II SRAMS for Virtex-7 FPGA. MIG IP core supporting maximum 9MB SRAM. So for one 32 MB Memory Support, we need four 9MB SRAMS and for another 32 MB Memory, other four 9MB SRAMS.So totally we need eight 9MB QDR II SRAMS. My query is When...
  4. naseer_39

    [SOLVED] Input Frequency Calculation using ADC Samples

    Ok now i get it by doing FFT we can know the frequency and Amplitude......Thanks for all replies....:)
  5. naseer_39

    [SOLVED] Input Frequency Calculation using ADC Samples

    Thanks for the reply.... Let me explain with example Suppose My A/D converter is fed with 50Hz frequency.With the 400K sampling rate , i need 8k number of samples to build one cycle. Is there any formula for finding out input frequency is 50 Hz in FPGA with 8k ADC samples. Thanks and...
  6. naseer_39

    [SOLVED] Input Frequency Calculation using ADC Samples

    Hi all, In our application , we are using a A/D Converter of resolution 18-bit with a sampling frequency of 400 Ksps and Voltage range is +/-10V. We want to find out the input frequency of A/D Converter.Is there any way to know the input frequency using number of ADC...
  7. naseer_39

    Regarding Depth(Distance) Calculation

    Hi, We are using a IMU triaxial sensor from MEMsense which gives Accelerometer,Magnetometer and Gyroscope data.I have calculated Pitch,roll and Heading. We are working on Borhole survey system . We need to calculate depth(distance) it has travelled into the borehole.I also need a clarification...
See more

Part and Inventory Search

Back
Top