Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What are you trying to do with it ?
I have a similar need, but conclusion was that it would be ebtter to use spice reader in ic6.1 , since it's already there/ready.
What version are you running ?
nmos current bias circuit
Could you explain further ? At that point differential signal swing is limited, so using the diff pair to extract the CMFB seems appropriate to me.
The only issue I see in what you highlighted is the fact that he is implicitly comparing it to the supply rail, and I...
Re: Questions about pipeline carlibration with LMS algorithm
I don't know if I understand your explanation correctly.
The sigma-delta ADC supplies the "error-free" conversion result. The LMS algorithm will use the difference between this value and the pipelined ADC one.
The aux ADC could have...
Re: Questions about pipeline carlibration with LMS algorithm
I did study the problem in the past.
I looked mostly at background calibration using PN sequences to dither the input signal and decorrelate the PN sequence out at the output. The LMS error model there is the suppression of the PN...
Re: Questions about pipeline carlibration with LMS algorithm
What is the error model you are calibrating against then ? Removing PN dithering from the decorrelated output ?
average salaries across europe
Switzerland is an expensive country, but the salaries are high and taxes are lower than most other european countries. Like US, but european, civilized, with health insurance coverage, school for all, free/cheap university.
Very clean, organized place. You pay...
Re: AMS HIT-Kit v3.51 p-well not avaliable & unbound var
3.51 is very old, I think it is meant to be used with IC 5.033 (or even 5.0) . Trying to run it with IC5141 may be the cause of the problem.
what best after phd italy
Could you comment on that ? I understand you are italian and you have accepted a job offer abroad.
What did you think of the offers/conditions in the countries you have not chosen ?
I was thinking of this the other day, and a colleague is leaving for a good job...
microelectronics phd europe
Have you applied to other places for MsC ?
Twente (B. Nauta), ETH, NTNU (Trondheim) for example ?
I think that the problem is that you will have to start at the MsC level, and this is rarely a paid position, at least in the first year.
If they accept you straight...
Input referred corner frequency in the 5 to 10 kHz range for min size (min area) device in 0.7um CMOS ?
It seems very low to me. At 200mV vgs-vth , for NMOS ?
1/f noise is not extensively/accurately measured in nanometer technologies, imho. No one cares much because the BW of the circuits are...
fail to load libinit.il
BTW, I did not mention this clearly,
To get the display to work correctly it should be enough to copy the display.drf file from the design kit directory tree (wherever you found it) to your cadence start-up directory (wherever you are when you start up cadence).
Either...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
