Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: My DC motor control
Thanks ,but with my schematic I can drive dc motor with current about 10A!
Or Not?
how about measurent voltage from Tachogenerator?
Please help me understand
My motor dc is 3A 30V with (tachogenerator 3v/1000 )
1.Is that correct shematic? :)
2.My tachogenerator connect to ANALOG IN of PIC . I must convert that voltage or can connect it without anything
3. Is that correct measurement current?
That is shematic:
mosfet stepper driver schematic
Please help
I found at piclist.com driver for stepper motor
that is schematic : http://www.piclist.com/images/member/RB-ezy-Q33/circuit.jpg
Question:
Can I change bipolar transistor TIP122 to mosfet irf830. If I change it,
maybe I can delete all of bc337...
Re: LCD 240x128 need help
Ok not PIC but I don't want to use FPGA
How about 2 PIC or DSpic
That don't metter . PLEASE help with simple function to drive an 1 Pixel on LCD
LVD Help
lvd connected to VDD : diode and cap
But please help me understand how use this if I use 7-segments LED
with common catode(-). How use separate VDD for LED and PIC with
diode and cap?
LCD 240x128 need help
This is Doc for LM24010z (240x128) LCD
**broken link removed**
PLEASE Help to write C-function to output pixel with some coordinates(X,Y)
Thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.