Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I am new to ARM world and trying to set my toolchain on eclipse, problem
is when I tried to install GNU ARM Eclipse Pluging it says,
'Cannot complete the install because one or more required items could
not be found.
Software being installed: GNU ARM C/C++ Cross Compiler Support...
u can use multi channel digital potentiometer to control it with microcontroller like AD5206 its a 4-channel digital potentiometer ic.
yes you can replace 4 potentiometers with microcontroller by using multi channel digital potentiometer as AD5206 is a 4-channel digital potentiometer...
the cheapest method of current sensing is thrown sense(shunt) resistor. and there will be two methods the high side and low side, low side method will be easier. I have made a current sensor with this method and it gives pretty nice results with resolution of 10mA.
Arduino is same as you program any microcontroller, plus point of arduino platform is, there are built in libraries for complex tasks and user don't need to bother much. you must know basics of C or C++. here are great tutorials made by JeremyBlum...
I have shared the link of author's page here all the values of components are mentioned..
and its strange why i m getting 40V:???:..
- - - Updated - - -
thanks to all guys, i found 2N3055 faulty and replaced them n its working. Now its working well n i am getting desired adjustment. But there...
hi
i am making a 1.5-28V 8A power supply using LM317 and 2N3055 as pass transistor, the problem is that i am not getting adjustable voltages at the end rather it remains constant to 24V but i am getting correct adjustable voltages in range of 1.7-27V at the OUT pin of LM317. any help and...
I am making a variable power supply, but i have encountered a problem that i m getting 48 V DC after rectification of 36V AC. As i need 10 amp current and i read from some where that 1000uf/amp capacitor is recommended so i have total capacitance of 7000uf, is this the capacitance that is...
problem is that windows not detecting, it says unknown device. When i connect it with my usb port a message window pops up saying "USB device not recognized ", but it works fine with my desktop.:(
Helo, i have made the USBasp programmer from https://www.fischl.de/usbasp/, its working fine on my desktop having win xp 32-bit, but when i connect it my laptop it says 'Unknown Device'. I have also tried to install the driver manually but got no result. If somebody encountered this problem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
