Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i got that SO pin.
i am trying to do this frm many days. learnt datasheet many times but i think i cant do it. no help from any side. no sample code from anywhere.
thanks for you kind help
have three qus
1. i have module which have the pinout as attached. there is no GDO1 and GDO2 pin. can you just tell me the which one is SO
2. different addition in address registers for different mode. can you explain this little.
3. to write some register value, i first have to send the addres...
i only want to use SPI interface. is GPO0 and GPO2 has any use in it?
- - - Updated - - -
and if i want to switch it in transmit to receive mode and vise versa?
i have learnt alot of codes and now got some sort of idea what i should do. i have some confusions if you can tell me
1: how to specify that module is in write or read mode.
2: the register values in the examples are not same which i calculate. i found no logic in the example codes. can you...
can you just tell me the flow of the code for both transmission and receiving. what i understand is
header files
initailize spi
send all the register values (have seen in many places)
send and receive commands
RSSI
end
kindly also mention how to set transceiver to transmitting and receiving...
hiz to all.
i need to use cc1101 to have RSSI extracted. i have searched alot for the code but couldnt found for pic MCU.
can anyone just guide me how to do this. i am not understanding from where i could start to do this.
i am using mikroc compiler. but also comfortable with other compiler...
hi to all
i have to implement a system which can generate single frequencies from 20MHz to 3GHz.
i have to use DDS with labview FPGA. i am searching all over about how to use DDS and FPGA (Labview FPGA).
i came to know that i have to use multiple DDS to do this. but i am confuss about the...
@goldsmith
i searched for TOP integrated circuits but didnt find anything, so i post again.
and for your kind information, you dont know how much effort i am putting so kindly dont criticize on me and control your words. you have no idea how many fishes i took out from sea.
next time be careful
Hi to all
i want to make a battery charger with low current in minimum cost. I want to use flayback topology.
Anyone have any idea of it. Nowadayz is market, most of the adapters are of flyback
my input is 220vac and output will be 14vdc to charge a battery
there are alot of application notes...
hi. how are you all?
i am stuct in a problem.
i want to make a device driver for windows.
my hardware will be usb interfaced with pic-microcontroller. i have developed full GUI based software to control all the input/output of microcontroller.
now i have to make a driver for usb to make a...
hi to all.
i have to switch a surge current of 100A for micro second to burst a resistor. i generated 600V and stored in capacitor
i want to use ssr to switch. for that purpose i bought a relay. the output section of the relay is 240VAC.
i tried to switch the dc voltage from that relay but it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
