Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks
but i use keypad to enter the speed look to circuit
and use shift encoder sensor to feedback
i need change in code and circuit
thans to your help
i wont to change this project to close loop
i use resistance and feedback shaft encoder sensor
i wont change in code in mikroc
code
unsigned long kp,speed=0,speed1=0,old=0;
char speed2,kp,x=1;
char key[]={'x','x',3,2,1,'x',6,5,4,'x',9,8,7,'x',10,0,11},txt[10];
void main()
{...
my project is speed control of dc motor using 16f877a and i use lcd and keypad
i enter the speed dc motor keypad. i need code in mikro c and circuit
dc motor like
24v
1000rpm
300watt
please help me realy i need help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
