Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Just designed and manufactered my BlueNRG-based PCB on ******, see attached picture for a 2-layer PCB with a PCB antenna works at 2.4GHz.
PCB specs:
Length : 55 mm Width : 30 mm Quantity : 10
Layers : 2 layers Thickness : 1.6 mm Surface Finish : HASL with lead
Finished Copper : 1 oz Cu...
Hello,
I'm asking about a tutorial or video for setting up the environment (Matlab, Code composer studio) for code generation for the TI C2000 F28035 uC.
Thanks in advance,
Moataz Fouad.
Hello,
I would like to use Simulink in Matlab R2014a to generate code for the Ti C2000 F28035 uC. After I configured Matlab i started Simulink but in my simulink library browser the "Target Preferences" block isn't available.
Can anyone tell me where is this block?
Thanks in advance,
Moataz...
Dear All,
I have the same issue but in OrCAD Layout ver 10.5. What is the fastest way to place/repeat a certain group of components in schematic & layout especially if we use the 'Load' feature in Layout 10.5 ??
Thanks in advance.
You may check the max. output swing vs (Vcc - Vss), for examples, you cannot get an output of +6V if your +ve supply is +6V; have a look on the datasheet of the OPAMP.
Hi student52,
You can check the following link especially page 27:
https://www.st.com/internet/com/TECHNICAL_RESOURCES/TECHNICAL_LITERATURE/APPLICATION_NOTE/CD00286111.pdf
Best regards.
But you can find some transformers with hight less than 25mm, you can use EE12 cores.
You can use PI Expert tool from Power Integration to help you optimize your design, check this link:
**broken link removed**
Hi rg21,
Have a look at the statistical signal processing toolbox of Matlab in the following link:
**broken link removed**
It contains many methods for PSD calculation.
Best regards.
Hi Mahammad,
You can start by creating your transmitter & receiver using simulink, communication tool box, it contains the analog modulation techniques you need like AM, FM & PM & other channel impairments.
Best regards.
Hi all,
Check the following link for a Complete PCB Design for the Electrical Engineer:
Complete PCB Design for the Electrical Engineer - Mentor Graphics
Best regards.
Dear Mithun_K_Das,
There are many methods:
1. Non-isolated solution: using a small resistor (around 1mOhm) in series with the DC current path, most probably you will need a signal conditioning stage to get a reasonable voltage levels proportional to the measured current
2. Isolated solution...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
