Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What is about to shame in this..??? Its not my fault that adk is not compatible with hfssv11...I am new to hfss at this time
and thanx for reply.
I have got my boundary conditons..:lol:
I do not know how to plot E and H plane radiation pattern separately in hfssv11.....
I have searched internet and found that
(In proj. manager->radiation->farfield->infinite sphere->
vary phi from 0 to 90 deg, stepsize 90 and vary theta from 0 to 360 deg. step size 3 to 10.
Second Step...
my microstrip antenna is as shown..
plz suggest me ..what should be the boundary conditions to be assign to the patches on lower and upper side and substrate (what to assign radiation,what to assign perfect E or H) ??
(substrate is FR4-epoxy)
can you tell me what should be the modifications in the circuit below ,to get more radio stations, as i am getting only 1 station which is also full of noise ?
Is it would be helpful of applying this oscillator circuit (below )in above circuit ?if yes then plz tell me which terminals should be...
my fm radio circuit is catching only 1 station of frequency 105.6MHz .I am changing variable capacitor but unable to tune more station,what should i do .
i am making this circuit fm radio ,,but sound is coming only when i am touching the top of 10k preset with screwdriver and the sound is full of noise (in high amount)
plz help so that i can make a good clarity fm radio.
there are two pins at centre of capacitor ,,so how they are connected to the common connection between C3A and C3B....
"i think that first we have to join both centre pins and then connected to the common connection between C3A and C3B"
is my answer right??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.