Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would like to create a face lumped elements. But i am unable to do so. Any advice?
Please refer to the pictures.
1. The whole structure.
2. The place where i want to create the face lumped elements.
3. Should be similar to the face discrete port which i have create.
<a title="1.jpg"...
Hi guys,
I am trying to study on Thermal simulation.
The first step i did was load a pre-defined structure, which is the hairpin filter. (Macros -> Construct -> Online -> Hairpin filter)
After that i saved the file.
Then i open a new template which is CST design studio, and drag the hairpin...
HI guys,
Transient simulation. Termination criterion.
" To obtain accurate broadband in Frequency domain the Electromagnetic energy in the computational domain needs to be sufficiently decay"
"If the energy is not decayed sufficiently the accuracy of the results suffer from the truncation...
Hi guys,
I hope you all bare with me, i am still a student and just started learning CST. Haha.
i got some questions here.
1. How do i get to use the "sweep curve..."
i cant seem to get it to work. What am i doing wrong? (please assume i know nothing)
as can be seen, the two rod, i would...
Hi guys,
I am doing RCS on a flat metal plate.
I made the plane wave rotate around the flat metal plate.
but somehow i could not get the 0D results.
it always plot 1 point only.
Any idea?
please advice. Thanks
- - - Updated - - -
Hi guys, here are some pictures.
Why does it only plot 1...
Performing RCS on a CPW antenna Using CST
Hi guys,
I have this project. A cpw model has already been constructed.
and my next objective is to perform RCS on it.
Can someone please advice me on how to do it?
I am using CST MWS software.
Thank you.
Please advice.
Hi guys, i just model a basic cpw. but i could not get the correct s-parameter result. I suspect it might be the port.
Do i need to add space? *background property*
below is the picture.
thanks
Hi everyone,
I just started exploring CST.
I am curious of this : "expert system"
Does anybody have a definition for this? how does it work?
kindly please explain. Thank you.
Thanks
Hi guys,
Can anyone give me a guide to build a one degree step for a servo motor.
Is it possible?
can i buy it anywhere?
thanks, take care,
regards,
microelectronics
Hi, erm, the idea of this project is whenever a key on a piano is played, e.g C . The hardware which is DE2 board, will then record the noise and will be able to identify which key is played and the musical score is generated and displayed onto the screen.
i am basically stuck on how to do the...
Hi guys,
I need you guys expert advice.
I'm new to vhdl language.
My project is to make a musical score generator using VHDL. It will be implemented on a DE2 board,altera.
The idea is, when a key/tone is played and the DE2 boards picks up the sound and generate the appropriate musical score...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
