Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi! I am designing a 3-phase Inverter by implementation of Deadbeat control on it with LC-filter. I want the basic model of that. If u have kindly provide me on sohaibchauhdary@gmail.com.
Re: dead beat control
Mustafa: If u have that work available with u, the modeling file using dead beat control can u please send them to me on sohaibchauhdary@gmail.com
Re: Quasi TEM
TEM mode is used for only conductor to conductor tranfer of waves in a single medium like in coplanar wave guide or other wave guides. where as quasi TEM is used when there are 2 mediums for wave to travel..means like in microstrip lne when from substrate m.w has to travel in...
i had made my fyp i.e. designing and fabricaion of millimeter wave detector...but there are some problems i am suffering from..the only soultion to them is to optimise it through m.w. office...kinly some 1 tell me the procedure of doing optimization in micro waves office.
same problem..please do tell me that what type of schottky diode i fix inside the microstrip line so that it detects millimeter waves..?pls do tell me its reply...
Re: impedance matching doubt
check out the smith chart after trying to match them if there is a dot on centre then impedance is matched try out by varying length and try to design it on single frequency.
how to design a milli meter wave detector?means how to do simulation of a coplanar wave guide connected with microstripline having a schottky diode in it for detecting power in it, excited by the power source and will have to match impedance of coplanar wave guide with microstrip line for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
