Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would want to replace the 500ohm trim pot (on the right) with the one on the left?
Can i use a 500 ohm trimmer? I am using it for voltage adjusting application only...
I am in need of a 15v 1a max regulated PSU to regulate a fluctuating 10-15v input source.
Does anyone have a schematic for the above?
I was recommended the LM2577....
I want to use a LM7815 chip to regulate 15v from a unstable 10-15v power source. But then the min input voltage of the LM7815 chip is 14.4-16v.
Is there anyway to boost the circuit to regulate 10-15v source to provide clean 15v 1a supply?
7107ic
Is it possible to replace the ICL7107 with a series of 74LS series IC to produce a 8 segment LCD DVM?
Does anyone has any idea how to go about doing it?
5vdc to 12vdc converter bangalore
Thanks a lot for the diagram.... I'll try it out if it works.....
Added after 1 hours 26 minutes:
I have searched farnel website for the components which you have listed on ur circuit diagram. The problem which i am facing nw is that there are many...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
