Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear All,
Searching for an Embedded software Engineer job vacancy part time or full time. or If there are any activities to be done in that field.
WR,
Eng.Maha.
Embedded software Engineer.
I use the 10-bit ADC "MCP3002" interfaced to AT89s52(using serial communication) to read the voltage changed using a variable resistance 1k ohm.
it reads 0V,and 5V but in between the value is not correct and i don't know the reason for that.
attached MCP3002 datasheet, c code, pcb.
summer training egypt
i don't know if any of them offer summer training.
but why don't you give them a visit and ask.
- sysdsoft in villa no.2, 162 st, ma3ady.
- newportmedia in msakan sherton
Added after 1 seconds:
i don't know if any of them offer summer training.
but why don't you give...
usb interfacing with pic16f877
i am with the opinion of using pic18f4550 microchip is already make the application on the pc through which you can communicate with your usb device , also the firmware you will put on the pic18f4550 which include the whole implementation for the usb protocal and...
GSM module telit GM862
hello
i have a problem when i used the AT command to enable GPRS and i couldn't send mail
till now the only successful part is powring on the module and accept at command
could any one help me to go on in this project iam so confused
tx-01
hi sokrat
u r right i did't interface this module to microcontroller yet as i was busy in another module but i was planning to try to interface it to the uart ...
but now i will take ur advice in my concideration and will work with IO pins
and could u plz send a simple grpgram to help us
kst-tx01 kst-rx806 project
hello
thanks for your replay
i want that encoder w decoder chip to make sure that my reciever is the only one who recieve my data
to avoid interference issue
is it possible without encoder and decoder chips?
i don't want to make my code complicated
thanks in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
