Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how simulink can solve nonelinear equations?
( unfortunatelly )the number of equatins is greater than number of variables " 12 equ & 6 unknown variables).
thanks :)
how can i work with "data" pin in hm-r and hm-t?
i wanna send 4 signal and and then control 4 IGBT (in receiver) with them.
i wanna use them in tiny robot , any IC els we need after receiver for decoding ?
my major is control and i dont know any thing about RF and communication , please help...
Why in MATLAB when we define A matrix as
A=[1 2 3;4 5 6;7 8 9]
whereas det(A)=0 (determinant(A)=0) , it give us this result for inverse of A:
inv(A)=
ans =
1.0e+016 *
-0.4504 0.9007 -0.4504
0.9007 -1.8014 0.9007
-0.4504 0.9007 -0.4504
why we have inverse when...
spice models
i wanna know about relation between technology ( for example for 1um transistor) and level in spice model
specially can you say which level use for 1um transistor?
level in spice model
i need info about "level" in spice models
and relation between transistor technology ( same as 1um) and level in spice models
are spice and hspice model different ?
with regards
arash
Added after 3 hours 4 minutes:
please help!!!
hello
i need 1 micron hspice model for mos, please help me.
i find another model same as 0.5 microns and 90 nano or 0.18 micron and ...
but i cant find 1 um technology , what can i do?
please
with best regard
arash
hspice model
thanks
but ,u know , i cant find more than 0.5 micron technology in www.mosis.org , tsmc and umc
what can i do?
i find a lot of spice model, but i cant find for 1micron
with regard
voltage and current difference
I made by moving energy between electrons
but V made by deference energy and potential between 2 point
I is in 1 direction but V is between 2 point
we have I if we have V
but maybe we have V between 2 point but we dont have I in there
Can anyone help please?
at first you must use M*C*delta(teta)=Q TO FIND energy
M is mass of plastic
C is spicial parametr for each material that u can find it in google or wikipedia
teta is your temperature
Q is your needed energy
now u can use Q=P*T=(V^2/R)T
v is voltage
r is resistor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
