Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
FvM , kalyanasv thanks again for your help
i will build each block shown below
as i said before this experiment just to be tested on oscilloscope, so any simple values for info and carrier signal are accepted..
please can you give me simple circuits for each block..
Kalynasv, Kerim, biff44, RCinFLA thanks alot..
how can i use the pll circuit in figure11 to generate fm signal just to be tested on oscilloscpe.
what i should connect to this circuit and how..
thank you FvM for your reply..
I need to generate fm using pll it is a condition..
if you can help me with a primary circuit,i will then make the calculation..
thanks again.
thanks for your help..But what i need is how to design pll for fm modulator without using any chip.
---------- Post added at 14:55 ---------- Previous post was at 14:51 ----------
yes u r right.. any values are accepted as long as it can be built and tested on oscilloscope.
waiting for ur...
Hi everyone
I need to design FM MODULATOR BY USING PLL but without using any IC or Chip.
I need to build the circuit and examine it on the oscilloscope only.
thank you in advance for any help..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.