Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I switched to 1N6338 that I have available and it worked.
The 1n6338 spec Vf 1.1V@200mA, trr=20ns. I am still trying to understand why it worked...so if you guys have insight please share.
Did all of that. Verified the LM using a PSU and it works as intended...but when connecting with the rectified circuit that's when nothing is working. The AC input drops and the regulator output is in miliVolts.
I am trying to convert my magnetic inductance voltage from L1 and C4. The AC input is about 25Vpp at 6.78Mhz. After going thought the full bridge rectifier, the voltage is about 15V with around 200mVripple. I am feeding this 15V into the LM317T, as seen on the schematic, to get 8V output but...
Ok. Forget telnet or ssh. I have data saved in memory...all I want to do is read that memory bank to see what is the value in it...basically how can I probe that memory bank.
Hi guys I have a MSP430f2012. I will be using it to collect and store an analog signal.
Here's the basic operation.
Read analog signal
Do ADC conversion
Store ADC somewhere in memory
Repeat and overwrite for long period of time
After say couple days I want to access that memory address and...
Ok I am working out on the tf please correct my logic. Since this is an inverting I am using the equation A=-Zf/Zs where Zf is R1||C1 which is R1/(1+s*C1*R1). I am a little confused on R2 and R3. How I am treating those to resistors?
Hi I am new to op-amps design. I would like to know how can I mathematically predict the output of a design. I want to setup the design based on the suggested design but dont know how to select for the different values of the components.
I'm thinking of mosfet. still getting comfortable with them. If using mosfet do I need another suppy voltage? is it possible to use my "Vs" for supply and as an output?
Here is a really simplified idea of what I am trying to get at. .
If J1=1, Vo=GND,
if J1=0,Vo=Vs.
Of course this is not what I want because while J1 is '1' current will drain to ground. I want to isolate the circuit (not power on at all) when J1 is '1' and when only J1 is open that's when...
Hi I am a recent graduate and still have a long way in learning analog design and I need help with one of my problem. I want to design some sort of 'selecting/switching mechanism' that chooses between 2 inputs (Vs and GND) to output all depending on what a third signal (Select) is, essentially...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
