Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
orcad missing model
Hi everybody.I know it has been a long time,however i am facing the exact same problem.Does anybody know how to solve it in Orcad v9.2?
Continuous line
In the sweeps tab under the name label you need to change the first value from phi to theta.This can be done by simply clicking on it and choosing theta.The first value is always plotted with a continuous line.
e plane pattern and h plane pattern
if you want to plot E you will have to specify r.You can create a near field sphere setup and specify a large radius in order to see the far fields.Then by choosing fields or near fields in results you will be able to plot E.I hope this helps!!!.
model dimensions are beyond the range hfss error
Model dimensions should be in the region 1e-006 to 10000 of your current default units.For example if the default length units are mm model dimensions should not be less than 1e-006mm or larger than 10000mm.So i suggest that you change default...
Thank you very much for your help!!!.
Well the monopole was not very well matched so i varied the monopole length using a parametric analysis.At 0,23*lamda s11 is about -30 dB.The radiation pattern is better but still not ok.If i achieve s11 less than -60 dB would it be almost like a circle for...
Hi everybody,
I am trying to simulate a lamda/4 monopole at 10GHz in hfss(version 9.0).I use a lumped port excitation(small rectangle) between the monopole and the infinite ground plane.The main problem is that the radiation pattern is not omnidirectional for 0<phi<360 deg at a constant...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.