Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Kicha10

  1. K

    Electromigration:- basic rule to be followed

    Thanks Sat for the reply :-)))
  2. K

    Electromigration:- basic rule to be followed

    Hi, Can anyone explain abt the relation b/w temp & current density which plays a role in Electromigration in detail. My undertanding is that, when Temp increases - delay increases (Ignore Temperature inversion concept), so the resistance will be more as delay increase, hence the flow of...
  3. K

    Some follwed beeps gives without stopping

    ----------- Hi, There are cases where If RAM is not placed properly, you may get this Beep error. Try check your RAM. ---------- Post added at 10:55 ---------- Previous post was at 10:53 ---------- Hi, There are cases where If RAM is not placed properly, you may get this Beep error. Try...
  4. K

    Why is the Delay Increases in Temperature inversion Corner ( i.e less than 0'C)

    Arjun, Thanks for the reply. I have already gone thru' this doc, but it gives the description of Temp Inversion and how it is applied. I want to know what is the cause for it, in sense why it is seen in 65nm and below but not above 65nm. What factors impact the delay in temp Inv corner ?? -...
  5. K

    Why is the Delay Increases in Temperature inversion Corner ( i.e less than 0'C)

    Hi, Why is the Delay Increases in Temperature Inversion Corner ? ~Kicha
See more

Part and Inventory Search

Back
Top