Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Wrapping a sheet around a spherical surface works as expected for me. I would need your exact error message to help out more.
Here is a small sheet next to a sphere before and after wrapping:
Here is a larger sheet next to a sphere before and after wrapping:
And this is the entry for...
This means that you have assigned two different boundaries which overlap. It actually is not an error, just a warning, and your file will still simulate.
The X next to "3D Model" means that you have an error with your geometry. It does not mean that the geometry is not 3 dimensional.
Can you post your exact error message(s) to help further diagnose your problem?
Hello Filip!
I am also working in the wireless power transfer area and HFSS is the primary software I use to simulate.
Here is a picture of a planar spiral inductor that I built in HFSS. Perhaps you could use a similar method to excite your coil.
Here is a close up on the lumped port used...
Hello!
There are a number of ways to draw arcs in HFSS. I'll briefly introduce you to a few here to hopefully get you in the right direction.
First, I'm going to assume that you're trying to draw something that looks like the image I've attached (image taken from an IEEE paper: Triple...
Hello,
Please update the image so that the vertical axis values may be seen. Also, can you upload just the project file (.hfss or .aedt) instead of the .rar?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
