Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I would like to program a DAC, in C, to convert in a audio signal from a ATEMEGA8 with I2C interface.If someone could gime me a hint...:cry:
I'm a beginner and I don't know where to begin from. I know something about I2C interfacing but is very difficil to start programming it...
Just a...
Re: Dot matrix displays
What I would like to know is how to connect this five dot matrix displays with Atmega8, because ATEMEGA8 has only 28 pins and I have to connect 25 pins and I would like to use as few as possible pins.
Thanks
HI,
How can I connect five dot matrix display 5X7 using multiplexing method.I whant to control the displays with a ATEMEGA8.
Thanks
:D
Added after 17 minutes:
Helpppppppppppp!:cry:
Hi,
I have a problem with Eagle.When I ADD new components in the shematic and I check the ERC I receive the answer that "board and schematic are not consistent" and when I look in the board file there is no package inserted.What I do wrong?...I'am a beginner:D:
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
