Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all respected,
I am using a IR remote control with 56Khz carrier frequency will it work on another devise which have same system code with key code but carrier frequency is change it is 38khz kindly give your feedback .
Regards
Dear All resspected,
Kindly suggest me what resistance would be require across in all carbon keys and carbon jumper for best operating in IR remote for Set Top box .
Regards
Dear Reapected ,
What will be the best value of an electrolyte capacitor for an IR remote control which is operating by 3volt batteries . kindly suggest .
Regards
- - - Updated - - -
Dear All respected ,
I am developing an IR remote control which will be operate by 3Volt battery and i...
Thanks all respected ,
Just clear to me as i mention, is this change of elco. cap. value could effect the battery life which is using in IR remote control .
Regards
Dear Albbg,
Thanks for your reply, actualy i want to use dual color led in a IR remote control and you know that in IR remote control we use 3v battery so is there any special specification required for dual color SMD led for remote.
second, 47uf 10v is mention in application circuit of IR...
dear all
I have two question
1. what happen if i will use 47uf16v elco. capacitor in place of 47uf10v ,Is it effect remote battery life?
2. Is dual color SMD led's come in two pin
Regards
when i operating set top box with ir remote control then remote hangs for a few minute and some time channel jumps where is the problem either in STB or remote?
Pls. suggest
dear respected members
i m designing single sided pcb for a remote control for a tv. so is there any relation between carbon tracks length and r current flowing in ckt if there any formula for calculate carbon vale for proper current flowing on ckt. so pls help me.
thanks and regards
dear all respected members
i have recvd a gerber data file .pho and i viewed it in dxp' camtastics but i would like to edit it in dxp so i couldnot do it i know that i have use some gerber data converter but i have not that if anybody resolve my problem i would be highly grateful to him. if any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
