Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
EMI simulation
I'm trying to simulate conducted emission in 3-phase water heater. Can you advise what program to use and how to start with it?
How accurate the simulation can be. Is it make any sens to simulate. Maybe i should rather measure (but how to do this without equipment)?
Re: PCB Track widths
Voltage has nothing to do with track width. For calculating track width's I use this program:
**broken link removed**
Voltage is important for calculating track to track spacing and in my opinion it will be ok to use 1mm/100V spacing.
regards
JG
I don't recommend using LM335 sensor in your application.
Manufacturers say LM335 have 1 degree accuracy but i took two sensors from different series and temperature they show differs 2-3 C
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
