Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: olimex pic gsm source code
Tell the truth, I don't use the olimex, I connect pic18f45k20 -> M33G GSM module (both 3.3V). But the problem is the same "i only read CR LF". I tried to pull up the RX and TX pin with 47k resistor. Tried to connect RTS to CTS, then DSR to DTR, but nothing. I...
Re: olimex pic gsm source code
I did what you suggest me, but it didn't help. It seems that I only get back the first and the second characters from all characters. I set the echo, I get the "AT" and no CR LF.
But I check the OERR after every ReadUSART, but there is not overrun.
Re: olimex pic gsm source code
But I would like to leave out the PC from the circuit. In this case I connect the serial pins (TX, RX) PIC<->GSM, then GSM RTS to an I/O pin of the PIC. Is it good?
Re: olimex pic gsm source code
But if I see the OK answer in the hyperterminal, why I don't see on the pin of the PIC? I connect only the RX and TX pin onthe PIC side, and on the PC side.
Re: olimex pic gsm source code
Could you explain how I should use the RTS line? At this moment I connect the PIC RX <- GSM TX, PIC TX -> GSM RX. I tried pull up the RTS but it does not help.
Thank you
Johnni21
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
