Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for your reply erikl. What program are you using to simulate this design?
I would also like to the ability to switch off/on the offset voltage applied. If I simply switch R6 out of the circuit, I think the impedance is mismatched at the input of the op-amp :?:. Can you recommend a...
Can this circuit work like you suggested earlier, without the op-amp and taking the output at node R5 & R6.
Or can the op-amp be configured with unity gain, and the scaling left as is? ....R4 = 0 ohms.
I'm designing a microcontroller application for controlling LEDs. The application is battery powered and the micro is running at +5V.
I need help on conditioning an input signal to the A/D of the micro. The input is a control voltage (CV) from Eurorack synthesizer module, and swings +/- 10V...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
