Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
your answer is correct... i think there was only an error in the conversion on the part of the author. the impedance in polar form obtained by the author when converted to rectangular form is the same as yours...
to check if a capacitor is working properly or not, you can use an ohmmeter. first, short the terminals of the capacitors to discharge the stored charge of the capacitor. then connect the ohmmeter across the capacitor. the ohmmeter should move from 0 ohms to large resistance or open ckt. if it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.