Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by issac newton

  1. I

    tracking robot design RF based

    i am trying to design a robot which can track a transmitter which produces rf signals in a given range of frequencies(example:- 400-900 MHz). i want to know the following details. 1. i have a design of wireless robot with A433MHz RF modules. i need to change the frequency of transmission...
  2. I

    selection of relay for driving an immersion rod

    the rating on the heating rod says this spec(may be it is the maximum spec). my rod does work with 230 V. but it uses a power socket as mentioned above(type M) so shud consume 16A. correct me if i am wrong.
  3. I

    selection of relay for driving an immersion rod

    i am designing a heating element control system. i am looking for a relay(with 5V input voltage if possible or 12V) which can control an immersion rod with specification 16-A & 250 V AC. The following are my questions. 1. the heater has to be driven with power sockets(type M sockets -16A). can...
  4. I

    gain bandwidth product of unity gain opamp

    thank u Mr.LvW. but theres a problem in my calc. as u said i found wp from the simulation plot by finding fp=302.26k hz(diagram) and finding wp=2*pi*fp. the K value is 11 (given by 11k/1k). using these values i land up with gb or wt as 11*wp=20.8*10^6, which means the opamp has unity gain till...
  5. I

    gain bandwidth product of unity gain opamp

    I Substituted A=GB/s not GB/2 sorry for the typo in the pic where alpha = r1/r1+r2 Sorry Mr.LvW, i dont clearly understand what u said. i derived the transfer function as shown in the picture. but how to find wp(cut off frequency) from the second equation. i can substitute 1/sqr(2) for...
  6. I

    gain bandwidth product of unity gain opamp

    i have attached a bode plot and the opamp dc second order lpf circuit. the opamp Tl082 has a gain bandwidth product of 4Mhz according to the datasheet. this circuit has a bandwidth of 414.25khz. can we determine the opamp' individual gain-bandwidth product from this plot ?? if yes , how do we...

Part and Inventory Search

Back
Top