Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all,
I have prepared following circuit and I have troubles with MOSFET driving.
Circuit info:
VDD = 2.8V (two fully charged NiMH AA batteries)
NE555N replaced by ST555CN (CMOS, from 2V power supply)
IRLZ44Z replaced by IRL3705N
Q2 MOSFET activated 1-2 times per minute for 0.1 second...
Thanks.
I found article about monostable 555 usage and it might work.
But I want avoid extra IC (I plan battery powered device) and I have following idea (please see attached circuit).
Idea is simple. Charge capacitor if schmitt trigger low (-1V) and discharge capacitor if schmitt trigger...
Hello,
I have made a circuit (strain gauge amplifier) - please see attached circuit.
Non-inverting Schmitt trigger attached to the out of instrumentation amplifier works fine and generates signal (+2V at "high" state, and -1V at "low" state).
So. Theoretically if we attach proper NPN...
I have used 0.1% tolerance resistors.
Question - it is possible to avoid possible excitation ripple using battery supply (such as Lithium coin cells CR3032)?
I will play a little bit with circuit... and if it won't work - i will use InAmp.
Hello!
I am beginner in electronics and i try to make instrumental amplifier for my strain gauge.
I have already made following circuit based on LM358, but i am not sure if it is OK.
I apply multimeter between Vref (LM336) and output and see voltage jumping up and down - from 4mV to 1.2V...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
