Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys,
I get lvs clean before exporting the gds file. However, lvs cannot recognize any port after exporting.
I tried to add pin in both "pin" and "drw" mode with lables.
I also check the calibre.lvs file, there is "LAYER PORT TEXT".
What may be the cause?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
