Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Convert analogue voltage to distance value(GP2D12 sensor
The reference website as shown below:
https://www.acroname.com/robotics/info/articles/irlinear/irlinear.html
The result as shown below:
I am new beginner in PIC microcontroller. I use PIC16F877A and Hi-Tech PICC LITE Compiler (C compiler). I already wrote C codes to get analogue voltage from GP2D12 distance sensor. But, i tried many times to convert it into distance value based on datasheet. I still can't get it. I NEED some...
How to get the sampled sine waveform by using "Simulink" in Matlab before the sampled signal enters into the digital FIR filter??? Any settings I need to set?? If the sampling frequency is 1kHz and cutoff frequency is 50Hz???
10s!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
