Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When I try to step in the debugger I get
ICD0137 invalid address (MT=01)(address=0xFFFFFFFF)
and the debugger says that the program is stepped, but nothing
happends with the arrow in the code?
Can anyone help?
Thanks predrage for all help.
Perhaps I need your help later.
The clock is now dead on the ICD2 and the target.
I will have to make a PCB for the construction.
icd0286: unable to communicate with icd
Thanks predrage
Changed the cable, the new is 15cm.
Static levels on max232:
pin2 +8V
pin6 -9V
pin7 -8V
pin8 -7,5V
When connect in MPLAB I get positive pulses on pin37 (RB4) on 16F877A.
Vdd= 5,02 V but ripple was 0,3V. When manupilating with some small...
inchworm icdwarn0054:
I have built the Stolz clone.
Using the bootloader 'BootLoader16F877A.HEX' I connect to MPLAB IDE 7.20 and get:
ICDWarn0034: Please ensure that your system's serial FIFO buffers are
disabled.
Auto-connect not enabled - Not connecting (Try enabling auto-connect on
the ICD2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
