Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
salary+leuven
Oh!
Why EU and US electronic company did not go to Vietnam!
In Vietnam, at Japanese company, 150$ for beginner, 200~300$ for skilled!
The salary is 3 times lower in domestic companies.
Software engineer earn a little higher.
If I use only some pins of development board, don't use pins will not in constrate file.
What happen if those pins connect to ouput pins of other device? Is it in HighZ state?
Please help me because I just begin in this side and I don't want to make my board broken.
program atmega8515
When I use Ponyprog to program Atmega8515, there are some problem with me:
- I used "AVR ISP (STK200/300) parallel port interface", but without the diode at Vcc. I could program the device even when forgot to power on the board (I have checked working of device after...
atmega8515
I want to use AT28C256 EEPROM with ATmega8515 as external ram (read only of course, for LED display).
It seem that there isn't any problem with timing.
Could you give me an advice?
Re: Help to get old IC...
That kind of equipment is too expensive. Don't waste it for recycled ICs.
If you like it, see https://www.hakkousa.com/products.asp?PID=850B&page=1
Re: Help to get old IC...
You should have 2 solder-irons. Put much solder to that IC, move your hand with both 2 iron quickly.
It is easy if that IC is not so big. (Except for BGA :D )
You have to wait for 14 days old and some post (5 is better) in order to become a downloadable member.
Many many books here:
But now, you can load some books from **broken link removed** (Don't forget login)
I guess that you come from dddt. This is a very good site. Show it at your forum :D
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
