Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi there,
I have an confusion about using adaptive and linear simulation at the same time.
Usually I use adaptive only, but now I need simulation at certain point. The guide said that I can add linear (or any other) simulation after adaptive simulation, and I did so.
However, in the...
Problems on Current Bias.
Hey guys, I confront problem during measurement on the following issue. Highly welcome to kindly leave any suggestions, analysis, even guess!
1) Description of the circuit: M1 is part of functional circuit; Pad Vbias and resister R are used to bias M1. M2 is added to...
Thank you a lot for your immediate reply!
I just sent a requesting email right before seeing your reply. It is wield because in this way, almost no interleaved structures in triple well could be achieved in this kits.
But anyway, I guess I will do what you said, using large devices and...
Dear all,
LVS reports an error "mal-formed device detected" on RF trible well nfet when I was making several symmetrical fets into one interdigitated one. If I change the nfet_tw with regular nfet, it is fine.
Did anyone have the same problem before? thanks for help!!
Hao
Hi, I kind of have the same problem. If I modify the regular nfet, it is fine. but once I flatten RF fet, "mal-formed devices detected".
So I wondered did you solve this problem after all? its been a while though.
Thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.