Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have designed the following circuit. It's supposed to be a low pass microstrip filter and a 50 ohm microstrip transmission line. Individually, each work with wave ports. However, I need to use lumped ports because I can't get accurate readings from the wave ports being the size I need them to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.