Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone, i am working on a project that requires me to interface a CDMA fixed wireless phone with a PABX device. The objective of the project to have a CDMA fixed wireless phone route calls to different extensions to provide communication facility in remote areas where landlines are not...
The valve can just be a water tap. I will decouple the tap from the valve and attach my motor instead. I can't be quite specific about the the valve but what kind of specification are you looking for? Describe
Hi, i am working on a project which requires me to control a valve using a stepper motor. I need guidance on how to figure out the size of the stepper motor that will be able to open and close the valve comfortably, such that the torque shouldn't be too low neither too high, we don't want to...
I am developing a project which requires me to design a website that can receive values from arduino microcontroller & log them in a data base. So far i have been successful in sending data to a my local IP address using ethernet shield. The next step requires me to develop a website,assign it...
I have found two solutions by doing some research. Please shed light on both solutions
1.Connect the app to a web server which receives data using a WI-FI ROUTER from an arduino which is connected
like in this representation:
https://imgur.com/nUDjktA
2.Connect a blue-tooth transmitter...
I am developing a system for a uni project that requires me to transmit data from an ARDUINO micro-controller to an android app. For instance, i am reading off values from moisture,light and temperature sensors and transmitting them to the arduino micro-controller and now i would want this data...
Position of a stepper motor*
- - - Updated - - -
Yes,obviously it doesn't take a mechanical quantity as an input but it does convert the input to a change in resistance.
I am designing a system which has sensors monitoring moisture,temperature and light and then it uses these parameters to control a motor. However,before implementation, i would like to carry out a simulation which provides simulation using ARDUINO MICROCONTROLLER as the coding is easier. Can you...
We are in process of designing an automated fruit packaging system. Part of this system requires us to design a mechanism which converts rotatory motion into linear motion. Can someone with a mechanical background ,please guide me on how to design such a mechanism?. The mechanism will be...
Can you recommend any h-bridge? We are also having trouble interfacing the tle6209 ic with the arduino microcontroller as it requires serial communication between the uc and itself. Plus There is no tutorial or help available regarding this h-bridge.
I wanted to say that when you connect the belt's motor directly to the power supply ,the motor kicks into action and the belt starts moving. I have not tested it yet with opposite polarities but the belt demonstrates the above behavior when directly connected to the power supply without any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
