Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi
I simulate an analog FFT in ADS(advance design system) Software by using CMOS current mirrors.
every current mirror has an little error because of nonideal the mirrors.
How I plot a curve that show FFT BER versus SNR?
nonideal the mirrors causes errors as mentioned above.
hi everybody
I have one problem :
I have one cisco 3560 switch.
one PC and some IP devices are networking on this switch.
IP devices Programmed and transmmit their information to a PC which have IP Address : 192.168.0.1
my problem is :
I want to read information from IP Devices by secendry PC...
thanks
I want to use substractor circuit in another circuit that has many current mirror.
other current mirror use for add the current.
I should have a same supply for all current mirrors.
What I should do now?
hi
I want to simulate a current substractor using cmos current mirror.
my circuit show in post below.
in this circuit first copy Iin1 , Iin2 using current mirror
and finally : Iout=Iin2-Iin1
How I can see Iout Value in simulating software?
I should use a current probe on head of Iout but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.