Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
Thanks for the Reply, im not really clear on it , from the diagram below , Pin 8 is my Vcc , while Pin 4 is my ground ,
when you say dual supply , do you mean i should modify my circuit as the one below:
Secondly :
from what you have explained its clear that
If Vin< 0, Vout = -Vin , and...
Re: Precision rectifier shows lower values than what i have input
not sure if you want the circuit diagram of the precision rectifier or the one i have built .. but i have attached the physical circuit , you can find the diagram here : https://en.wikipedia.org/wiki/Precision_rectifier
i used...
Hi All
i have a problem with my full wave precision rectifier using LM358 , i observe lower voltages than what i have as input,
firstly i drew the circuit on a simulator and fed in dc as input with a variable resistor connected, the output measured is the same as the DC input ,
when i built...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.