Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello everybody,
please can anyone guide me on how to display the 4066 IC hidden pins on Proteus?, as i am working on drawing schematic which include 4066, and need to connect its pins with other components in the circuit, and only 3 ins are displayed when i choose it from the Proteus library...
how much ampere is your brother muscle stimulator Brad?,
as the output amperes for my circuit design won't exceed 100 micro-ampere, " Very low ampere", and high voltage
Thanks again for your care to response
here is me configured the block diagram, according to the information you told me about, and i think it should work this time, let me know FVM if the transformer will work this time, and if not, what component you see i have to replace the transformer with...
well, i am new to the electronic circuits design, and i am mainly mechanical engineer, but with some good knowledge and interest into electronics which i believe that it will help me finishing such a project " hopefully", with some search and experts help, as you FvM and barry
FvM the load will...
i won't apply DC voltage to the primary coil of the transformer, i will apply sine wave form at frequencies range from 10-1khz, and with a specific turn ratio of the transformer i can get the desired voltage
do you suggest any circuit for converting the amplified audio signal to sine wave form...
Hi barry,
Thanks for your response, i searched more yesterday, and i could find very close design to my design specifications, with micro-controller, and LCD display, with the source code, but i will just have to configure the code as i need
the 100 , refers to full scale , yes, and no there...
Hello everybody,
i am working on electronic circuit design, which takes audio input up to 1khz waveform, "the audio wave forms are different and at different frequencies", its maximum frequency is 1khz
and required to output the same frequency at voltage from 20-450v , at very low ampere "...
okay, thanks for your replies,
it worked for me, and i just had to add the voltage probe at the output place , then add traces , then simulate
Thanks again
hello everybody,
i am new to proteus, and i am working on audio amplifier circuit, that circuit in the attachment, and i need to simulate the output signal before the speaker, to test the amplification of the input signal
i could simulate the input as shown in the picture, but i don't know...
Hello everybody there,
Again i'm asking about any simulation software, which does simulation for the above circuit, transmitting and receiving signals test, on the freqeuncy of 433mhz, before prototyping, as i don't wanna try and error on real testing, so would prefer to simualte first, so can...
i understand the circuit, and i know it's simple, but just nothing work when simulate it on proteus, does nyone here knows why?k, or can anyone draw such a simple circuit like this on proteus and capture and attach for me?
Thanks for the reply,
Samy, my battery voltage is 9v, Type is AAA battery, and which op-amp i should use?
Wixt: i understand that it will light the led when it's 8v, and no need to light when it's lower
my requirements is a schematic diagram which work for sure when connecting
another...
hello everybody,
please i need a low voltage battery indicator, and the battery to be 9v, or 3v, to indicate a red led when the battery gets down under the 9v or the 3v, and please i need reliable circuit " one when make to work for sure", cause i got many from google and when simulated on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.