Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I use a diode to reduce the speed of the AC "shaded-pole motor". but there are some issues:
"noise" and "vibration" of the motor has been increased. ( there is hum voice )
is this vibration and noise damage the motor?
thanks.
Hi,
i have a problem with this part that i think that is a smd Diode. ( picture has been attached )
but i do not know what is it's specification. ( model, company , ... )
would you please help me?
thanks you, yes, filter is correct. but how can i get correct result? in second filter if i increase my signal samples data from 40000 to 100000, but filterign result not acceptable. filter result is too noisy yet.
is there any idea to design a filter that pass only 14.8Hz signal?
thanks
thank you. this is Kaiser bad-pass filter and it's work fine. the point is when 14.7Hz signal and 15.1hz signal amplitude growing up, this filter do not work properly. in this sample r1 ( amplitude of 14.7Hz ) and r2 ( amplitude of 15.1 Hz ) is too big than main Signal ( 14.8 Hz and it's...
I try to simulate a noisy signal and Filter it. the signal mix some low frequency signals and some random noise. my goal is to get 14.8Hz signal. my band-pass bandwidth is 14.7Hz to 14.9Hz.
function filteringTest
Hd = KaiserFilter;
Fs = 4000; % Sampling frequency
T =...
Hello,
I have two PCB s with difference part. i want connect those over each other like this :
( because there is limited space )
How could minimum space between two broad be?
Thanks.
hello,
i used this circuit to turn on lcd back-light(EL) like this :
and this :
but it Sometimes blinking for 4-6 second.( i do not know why )
is there any idea?
thanks
Hello,
I used very simple power supply for my circuit that used a micro-controller.
in my board exists 7812 for stabilization.
is it suitable fr micro?
If i use it, what problems may be occur?
thanks.
Hello,
I have a 220v (AC) heating element. like this :
**broken link removed**
it's work fine and resistace between of terninam and metal body is over 100 mega ohm.
**broken link removed**
but when i turn on the circuit, it's body has ac voltage. i think it is an induced voltage. is it true...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.