Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi folks,
I'm using a JK flip flop to build a counter in high level, and my flip flop has Clock ,J,K input and Q,Qbar output,
I'm supposed to connect the J and K to high , apply a clock pulse to input ,so it will toggle at clock pulse edges,
But the flip flop doesn't work .and the output is...
Hi everybody
I'm wonder does any one knows that if its possible to get the CDF (cumulative Density Function) diagram in cadence spectre?
or it should be done through Matlab
Appreciate for help and hints
regards
Farid
Thanks so much for your response, that was very helpful
---------- Post added at 12:44 ---------- Previous post was at 12:43 ----------
thank you so much for your explanation ,helped me a lot
---------- Post added at 12:45 ---------- Previous post was at 12:44 ----------
Appreciate for your...
Help! How to add multiple signal together in cadence
Hi folks,
I need to add multiple (32 signal or another way add 32 wire ) together in cadence ,
anyone know how to do it with *OR* gate in cedence. because it has two input, and I need 32 input actually
*I'm working with verilogA model of...
Hi folks,
Anyone know how to introduce a pulse with some jitter!!,
by jitter I mean , variation in rising edge of the pulse(square wave pulse )
I tried to input a sawtooth and a DC voltage to a comparator , and get square wave pulse at output, now if I can add some noise to...
H folks,
I need to produce a sawtooth wave with freq=400MHz in simulink but I cannot create it either using *Repeating Sequence* or * signal generator*
since the output has nothing to do with what I need and specified, and it goes so wrong form a sawtooth ,
I'm wonder anyone faced the same...
Hi folks,
anyone know how to introduce a DC voltage in simulink ? there is a Dc vlotage block in SimpowerSystem and in Simscape libraries but they cannot be used in simulink ,how I can introduce for example 1.8 v DC voltage in simulink...I need to add it to some othe signal
thanks in advance...
Hi all,
I need a jittery clock signal( jittery pulse) to test a vernier delay line circuit, any one know how to produce such a jittery pulse and by jittery I mean random variation of only rising edge of a pulse ,I appreciate for any hint or paper
regards
farid
Hi folks,
I'm designing a vernier delay line in cadence, and I need a pulse to be delayed by a delay element for a number of times,
for delay element I used an inverter with width a pmos twice the nmos but the result is like spiky not pulse
I'm wonder anyone know about a delay element in...
Problem in produce Jittery clock (signal) in simulink
Hej every body,
I`m wonder if anyone know how to produce a jittery clock signal in simulink ?
I'd be appreciate for your guideline
regards
Farid
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.